Unplugging Attachment Cables; Plugging Attachment Cables; Unplugging Utp Cables; Installing Or Removing A Token-Ring Attachment Cable - IBM 950 User Manual

Unplugging Attachment Cables

Step
Step
Figure C-5. Installing or Removing a Token-Ring Attachment Cable
Step

Plugging Attachment Cables

Step
Step
Step

Unplugging UTP Cables

Step
Step
Plugging in a UTP cable, step 1 on page C-6.
1
To unplug an attachment cable, first ask the network operator to
deactivate the line.
2
Loosen the retaining screws and pull out the connector. Repeat this
step for every attachment cable that you need to unplug.
3
Update the plugging sheets, and to integrate the changes that you have
made, go to "Updating the Active CDF-E" on page 3-17.
1
To plug in an attachment cable, check that the cable is correctly labeled
at both ends.
2
Push in the connector and tighten the retaining screws (see
Figure C-5). Repeat this step for every cable that you need to plug in.
3
Ask the network operator to activate the lines of any newly installed or
replaced cables. If activation does not work, see "Solving Problems" on
page 1-5.
1
To unplug a UTP cable, ask the network operator to deactivate it.
2
Pinch the UTP cable connecter and pull it out (see A in Figure C-6 on
page C-6).
Appendix C. Installing LCBs, ARCs, and Connecting Cables
C-5