VTAM Definitions
The VTAM definitions in this section are for Version 3 Release 4.1.
Start Definitions
The following VTAM start definitions must be used in both VTAM1 and VTAM2, as
shown in Figure 11-1 on page 11-1:
*
*
*
HOSTSA=10,SSCPID=10,MAXSUBA=63,
CONFIG=10,NETID= SYSTST
XNETALS=YES,DYNLU=YES,
NOPROMPT,DLRTCB=32,SUPP=NOSUP,NOTNSTAT,NOTRACE,TYPE=VTAM,
LPBUF=(120,,0,,60,60),
LFBUF=(96,,0,,24,10),
SFBUF=(128,,0,,32,10),
CRPLBUF=(160,,13,,80,80),
IOBUF=(256,256,34,,68,68)
Log mode Table
The following VTAM log mode table must be used in both VTAM1 and VTAM2 as
shown in Figure 11-1 on page 11-1:
.
.
***********************************************************************
*
*
TIC3
GROUP L78G2080: LAN LOGICAL DEFINITIONS FOR 37CS
*
*
***********************************************************************
L50G2080 N GROUP DIAL=YES,LNCTL=SDLC,TYPE=NCP,ECLTYPE=(LOGICAL,PER), *
CALL=INOUT,PHYSRSC=S50C2080,
LINEAUT=YES,
MAXPU=1,
NPACOLL=NO,
PUTYPE=2,
RETRIES=(6,0,0,6)
R50A0001 LINE
Z50A0001 PU
.
.
.
VTAM START DEFINITIONS
Chapter 11. Using DCAF with an SNA-Attached Remote Workstation
A ,SSCPNAME=CDRM12,
LARGE GENERAL PURPOSE _ PAGEABLE
LARGE GENERAL PURPOSE _ FIXED
SMALL GENERAL PURPOSE _ FIXED
RPL_COPY _ PAGEABLE
I/O BUFFERS _ FIXED (NP & PP BUF REMOVED)
*
*
*
*
*
*
*
*
*
11-13