Figure C-6. Installing or Removing a Token-Ring UTP Cable and Media Filter
Unplugging Token-Ring UTP Media Filter
Step
Step
Step
Plugging Token-Ring UTP Media Filter
Step
Step
Plugging UTP Cables
Step
Step
C-6
3746-950: User's Guide
1
To unplug a token-ring UTP media filter, ask the network operator to
deactivate it.
2
Loosen the retaining screws and pull out the media filter (see A in
Figure C-6).
3
Update the plugging sheets, and to integrate the changes that you have
made, go to "Updating the Active CDF-E" on page 3-17.
1
To plug in a token-ring UTP media filter, check that the cable is
correctly labeled at both ends.
2
Insert the media filter into the TIC3 connector and tighten the retaining
screws (see A in Figure C-6).
1
To plug in a UTP cable, push the connector into the media filter socket
until it clicks into place (see B in Figure C-6).
2
Ask the network operator to activate the lines of any new or replaced
cables. If activation does not work, see "Solving Problems" on
page 1-5.