Table of Contents
Advertisement
Step
Step
Step
NCP Definitions
The definitions in this section apply to NCP Version 6 Release 2.
All NCP generations attached to LUs that support LU 6.2 DCAF sessions must
contain the following statement:
Remote Controlling Workstation
The following definitions apply to NCP1 between the controlling workstation LAN
and the SNA network (see Figure 11-1 on page 11-1).
The address must be the same as defined in step 9 on page 11-7.
7. Fill in the Local LU alias field, the Partner LU alias field (see Table 9-1
on page 9-1), and enter DCAFMODE in the Mode name field. Then click
Save, OK (on the subsequent panel), and Cancel.
8. Shutdown and restart the workstation.
9. The installation is complete. For more information on using this new
DCAF session, see "Using DCAF to Remotely Log On to the Service
Processor."
LUDRPOOL NUMILU=(any number > 0)
1. Physical line and physical PU:
Chapter 11. Using DCAF with an SNA-Attached Remote Workstation
11-11
Advertisement
Table of Contents
