Configuring Resources; Managing Resources - IBM 950 User Manual

Configuring Resources

For a more detailed description on using these commands, refer to Nways
Multiprotocol Routing Services, and the Software User's Guide.
Step
Step
Step
Pressing
back to OPCON (the RANGE XXXX-YYYY * command prompt).

Managing Resources

For detailed use of these commands, refer to the Nways Multiprotocol Routing
Services and to the Software User's Guide.
Step
Step
1 These commands take effect immediately and there is no need to restart your system.
1
On the Range XXXX-YYYY * command line, enter T 6 for the Config>
command prompt.
2
Enter ? to display the list of the available configuration commands.
Exit Returns to the previous environment level.
F BRS For a given interface, adds deletes or changes the
default class, and assigns or de-assigns a protocol or
filter 1
List Displays the configuration and devices list.
Logout Exits the Telnet session without saving changes (the
keyboard shortcut is pressing
together).
Network Enters the configuration network (port) environment.
P IP Add, delete, or change a route (static routes), and add
or remove a filter
P OSPF Add or remove a neighbor
Patch Used only by an IBM representative.
Protocol For entering a protocol environment (IP, ARP, etc).
Set For setting parameters.
Unpatch Used only by an IBM representative.
3
Entering ? after a command name displays any associated
sub-commands.
and together returns you from the environment that you are in
1
On the Range XXXX-YYYY * command line, enter T 5 to display the
GWCON command prompt (shown as RANGE XXXX-YYYY +).
2
Enter ? to display the list of the available management commands.
Range For other adapter range addresses.
Buffer Displays the interface buffer size and utilization.
Clear For clearing interface statistics.
Configuration Displays adapter protocol and interface configuration.
Chapter 5. Telnet IP Resource Management in CCM and MOSS-E
.
1 .
1 .
and
5-7