Table of Contents
Advertisement
User Manual
3.1.2
First connection as remote working
When you connect your desk phone for the first time remotely, you are prompted to set a PIN code.
The PIN code is requested when you enter in the VPN configuration (submenus) or when you boot your
desk phone (depending on the VPN configuration).
The PIN code is retained during the session so that you can access the VPN configuration without having
to re-enter your PIN code until you exit the VPN configuration.
Before configuring your phone for remote working, check if you have all the information from your
administrator.
If your desk phone is equipped with the magnetic keyboard, use it to enter letters. If not, use the
alphanumeric keyboard to enter letters. Use the alphanumeric keyboard key to switch between the
numeric and alphabetic keyboard. When in alphabetic mode, the LED corresponding to the key remains
lit up.
The ALE-500 Enterprise DeskPhone has a virtual alphabetical keyboard displayed on the lower half of the
screen by sliding the screen to the left.
To configure your desk phone:
•
Access to the administration menu of the desk phone (see chapter above).
•
VPN
(scroll down the menu).
o Enter the new PIN Code.
Validate.
o
•
VPN Config
Enable
VPN: you have to activate this option to use your desk phone for remote working.
o
VPN
Server: enter the address of the VPN server.
o
Validate.
o
VPN
PSK: enter the pre-shared key to establish a secure connection with the VPN server.
o
The PSK can be unique for all remote workers on a same installation or can be specific to
each remote worker. In the first case, the VPN authentication has to be enabled.
IKE version:
o
o Other advanced settings if requested:
force
encapsulation,
Validate.
o
•
VPN Tftp Use TFTP servers, tftp1,
option and enter the addresses and port of the TFTP servers.
Validate.
•
VPN Authent Use
server (username and password) is required. The VPN authentication can be disabled in case a
specific PSK is used for each remote worker.
Validate.
•
VPN Pincod Request Pincode on
you boot your desk phone. We recommend you activate this option.
Validate.
•
The VPN configuration is saved and the main menu is displayed.
•
Select this icon to exit the configuration menu. The desk phone restarts.
•
Enter the PIN code if you have selected the option
•
Validate.
•
Your desk phone is ready for remote working.
Select this icon to save parameters
8AL90399ENAAed01
Enter the IKV version (IKEv1/IKEv2).
Static Virtual IP (VIP
tftp2,port: if the TFTP servers are required, activate this
Authentification, User, Password: activate this option if a logon to the VPN
Boot: if this option is activated, the PIN code is required when
IKEv1 aggressive mode
Addr).
(Request Pincode on
(when IKEv1 enabled),
Boot).
54 /101
IKE
Advertisement
Table of Contents
