Table of Contents
Advertisement
User Manual
5.5.3.1 Remove the customization kit
A
Slide your fingernail along
1
the piece to detach it from
the phone.
Pull perpendicular to the
desk phone along the entire
2
length of the piece. Be
careful not to break the
clips.
3
4
5
5.5.3.2 Install the custization kit
A
Place each clip facing the
corresponding notches. Be
careful to place the piece in
1
the correct direction: the
logo must be on the right
hand side.
Press perpendicular to the
desk phone all along the
2
piece. Press gently so as not
to force and break a clip.
3
8AL90399ENAAed01
B
This piece is clipped to the four
corners. We recommend starting
from the back of the desk phone.
Carefully insert a thin, non-sharp
object over the colored piece on
left side.
Gently lift the piece by pushing
forward (you will hear a small click
when the piece is removed).
Insert the thin, non-sharp object on
the right side.
Gently lift the piece by pushing
forward (you will hear a small click
when the piece is removed).
Remove the piece by rotating it as
shown in the drawing.
B
Insert the piece around the speaker
of the station.
Press as shown in the drawing to
clip the piece in the front (you
should hear a small click when the
clip is in its notch).
Push the piece by slight rotation
until it is in its place.
Press as shown in the drawing to
clip the piece in the back (you
should hear a small click when the
clip is in its notch).
C
Press, then slide the
piece towards the bottom
of the device a few
millimeters with your
thumbs.
Remove the piece by
lifting it.
Be careful not to break
the clips.
C
Place the piece by
respecting the notches.
Slide the piece to the top
of the hands a few
millimeters with your
thumbs.
84 /101
Advertisement
Table of Contents
