Function Programming; Language; Rinsing - Gaggia SYNCRONY DIGITAL Operating Instructions Manual

• Turn the knob clockwise (16) to close.
• When the descaling cycle is over, quit the
program by pressing "ESC".
The machine will display the message
FILL WATERTANK
Note: After descaling, clear the
message "DESCALING", as described
under para. 11.1
Note: the descaling program and
rinse take about 40 minutes.
If you use a product other than the
recommended one, you should follow the
manufacturer's directions on the package.

12 FUNCTION PROGRAMMING

The user can change some machine
operating parameters according to
personal needs.
12.1 "ENT" command
In order to program functions you must access
the programming mode by pressing "ENT" (25)
when the machine is in a standby status.
Press (25) "ENT" and keep it pressed down until
the display shows:

LANGUAGE

RINSING

To select the desired function, press the "∧ ∧ ∧ ∧ ∧ "
button to move up one line or the "∨ ∨ ∨ ∨ ∨ " button to
move down on the display.
To exit the programming mode press "ESC"
12.2 Choosing individual functions
Select the desired function by pressing "∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ ".
Press (25) "ENT" to enable the desired function;
you can browse the selectable settings using the
"∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ " button; to store a setting press "ENT".
Note: by pressing "ESC" you can exit
the programming mode at any time
without saving the changes made; exiting
without saving is possible only before you
have pressed "ENT".
12.3 Description of programmable
This function allows you to change the
language of the display. You can choose
among Italian, German, Portuguese, Spanish,
English, French and Dutch. The appliance is
normally set on the language of the country it
is to be sold in.
• After accessing the programming mode, press
"∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ " to select the function:
and then enable it by pressing "ENT".
The display will show:
Press "∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ " to select the desired language
and then press "ENT" to memorise it.
*
Immediately after heating up, the appliance
automatically eliminates the water left standing
in the internal circuit to ensure that only fresh
water will be used to make coffee.
The function is activated in the factory.
• To deactivate it, go to the programming mode
and press "∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ " to select the function:
and enable it by pressing "ENT". The following
message will appear:
• 35 •
functions
LANGUAGE
LANGUAGE
LANGUAGE
ENGLISH
RINSING
RINSING
RINSING
ON
ENGLISH