National Instruments FieldPoint cFP-21 Series Quick Start Manual page 6

324033b.fm Page 6 Wednesday, September 14, 2005 2:09 PM
104.74 mm
(4.1 in.)
63.46 mm
127.00 mm
(2.5 in.)
(5.0 in.)
22.19 mm
(0.9 in.)
2. Bolt or screw the panel-mount accessory to a panel.
3. Connect the PE ground terminal on the cFP-BP-x to safety ground.
Caution Disconnect power before removing the backplane from the
panel.
Mounting the Backplane on a DIN Rail
NI recommends DIN rail mounting for the cFP-BP-4 only. Use panel mounting or
rack mounting for the cFP-BP-8. The DIN rail mounting kit is NI part number
778614-01.
1. Fasten the DIN rail clip to the cFP-BP-4 using a number 2 Phillips screwdriver
and the 8-32 × 5/16 in. countersink screws shipped with the clip.
cFP-21xx Quick Start Guide
245.87 mm
(9.6 in.)
6 ni.com