National Instruments FieldPoint cFP-21 Series Quick Start Manual page 3

324033b.fm Page 3 Wednesday, September 14, 2005 2:09 PM
If you are using UL Recognized I\O modules with the Compact
Caution
FieldPoint system, you must install the entire system in a suitably rated,
UL Listed NEMA or IP enclosure.
NI recommends that you use one of the mounting systems
Caution
described in this document. If you decide to use a custom mounting
solution, make sure that the screws you use are short enough to fit in the
holes in the backplane. The screw holes are 5 mm (0.2 in.) deep.
© National Instruments Corporation 3 cFP-21xx Quick Start Guide