National Instruments FieldPoint cFP-21 Series Quick Start Manual page 11

324033b.fm Page 11 Wednesday, September 14, 2005 2:09 PM
3. Install I/O Modules on the Backplane
1. Align the captive screws on the I/O module with the holes on the backplane.
2. Press firmly to seat the I/O module on the backplane.
3. Using a number 2 Phillips screwdriver with a shank of at least 64 mm (2.5 in.)
length, tighten the captive screws to 1.1 N · m (10 lb · in.) of torque.
4. Repeat this procedure to install additional I/O modules on the backplane.
© National Instruments Corporation 11 cFP-21xx Quick Start Guide