Charging the Battery using the supplied USB-AC adapter
# The battery will not be fully charged at the time of purchase. Charge the battery before
use.
1
1
Check that the battery is in the camera, and connect the USB cable and
USB-AC adapter.
• When attaching the USB cable, use the supplied cable protector and cable clip to
prevent damage to the connectors. g "Attaching Cable Protectors" (P. 19)
%Refrain from using anything other than the USB cable (CB-USB13) supplied with the
camera or sold separately.
USB-AC adapter
(supplied)
• The battery charge lamp lights during charging.
Charging with the camera turned off takes about 2
hours 30 minutes. The lamp goes out as the batteries
reach full charge. Remove the USB cable from the
camera.
# If a charging error occurs, the battery charge lamp will
blink. Disconnect and reconnect the USB cable.
%The battery will be charged regardless of whether the camera is turned on or off.
The charging time will be longer if the camera is on.
%Charging stops when the battery temperature is too high. It will resume after the battery
temperature falls.
%A charger (BCX-1: sold separately) can be used to charge the battery (P. 294).
%For safety reasons, charging may take longer, or the battery may not reach full charge,
when the battery is charged in a high-temperature environment.
#
The USB-AC Adapter
• Be sure to unplug the USB-AC adapter for cleaning. Leaving the USB-AC adapter
plugged in during cleaning could result in injury or electric shock.
22 EN
AC outlet
USB cable
(supplied)
USB connector