Olympus OM System OM-1 Instruction Manual page 127

Y12s / tY12s
Self-timer 12 sec
♥Y12s
Y2s / tY2s
Self-timer 2 sec
♥Y2s
YC / tYC
Custom Self-timer
♥YC
%You can choose the frame advance rate and the maximum number of shots in each series
(P. 128).
%Items marked with t allows you to take pictures with the small amount of blur caused by
operation of the shutter reduced. Use this option when even slight camera motion can
cause blur, for example during macro or telephoto photography. This option is available
when [Anti-Shockr] is set to [On] in [Anti-Shockr Settings] (P. 131).
%Items marked with ♥ use the electronic shutter. Use these with shutter speeds faster than
1/8000 seconds, or in settings where the sound of the shutter would be unwelcome.
%♥jSH2 and ProCap SH2 can only be used with specific lenses. Visit our website for
details.
%To cancel the activated self-timer, press G.
%In j, tj and ♥j and ProCap modes, the camera displays the view through the lens
during shooting. In ♥jSH1, ♥jSH2, ProCap SH1, and ProCap SH2 modes, it displays
the shot immediately preceding the current frame.
# When using ♥jSH2 or ProCap SH2 with [C-AF], [C-AFb], [C-AF+TR] or
[C-AF+TRb] selected for [KAF Mode] (P. 72) and an aperture value larger than F8,
the focus accuracy will decrease. (F will be displayed.
# In ♥jSH1 and ProCap SH1 modes, the lower limit of the shutter speed is 1/15 s.
# In ♥jSH2 and ProCap SH2 modes, the lower limit of the shutter speed is 1/640 s when
[Max fps] under [Sequential Shooting Settings] is set to 50 and 1/320 s when it is set to
25.
# Shooting speed will be lower when [KISO] is 16000 or higher.
# When [KISO] set to 16000 or higher in ♥j mode, the flash sync speed will be 1/50 s
and the shooting speed will be limited to a maximum of 10 fps.
# If you stand in front of the camera to press the shutter button when using the self-timer,
the picture may be out of focus.
# The speed of sequential shooting varies depending on the lens you are using and the
focus of the zoom lens.
# During sequential shooting, if the battery level icon blinks due to low battery, the camera
stops shooting. The camera may not save all of the pictures depending on how much
battery power remains.
# Photographs taken in silent and pro-capture modes may be distorted if the subject or
camera moves quickly during shooting.
# To use the flash in silent shooting modes (P. 132), select [Allow] for [Flash Mode] in
[Silents Settings] (P. 132).
The shutter is released 12 seconds after the
shutter button is pressed all the way down. The
self-timer lamp will light for about 10 seconds and
then start to flash about 2 seconds before the
shutter is released. The camera focuses when the
shutter button is pressed halfway.
When the shutter button is pressed all the way
down, the self-timer lamp will start to flash and
a photo will be taken after about 2 seconds. The
camera focuses when the shutter button is pressed
halfway.
Adjust self-timer settings, including the self-timer
delay and the number of shots taken when the
timer expires (P. 130).
4
127
EN