Power On The Device - Cisco Firepower 2100 Getting Started Manual

Firepower Threat Defense Deployment with FMC
Figure 13: Cabling an Edge Deployment
Note
a) Cable the following to a Layer 2 Ethernet switch:
b) Connect the management computer to the console port. You need to use the console port to access the
CLI for initial setup if you do not use SSH to the Management interface.
c) Connect the outside interface (for example, Ethernet 1/1) to your outside router.
d) Connect other networks to the remaining interfaces.

Power on the Device

The power switch is located to the left of power supply module 1 on the rear of the chassis. It is a toggle
switch that controls power to the system. If the power switch is in standby position, only the 3.3-V standby
power is enabled from the power supply module and the 12-V main power is OFF. When the switch is in the
ON position, the 12-V main power is turned on and the system boots.
Before you begin
It's important that you provide reliable power for your device (for example, using an uninterruptable power
supply (UPS)). Loss of power without first shutting down can cause serious file system damage. There are
For version 6.5 and earlier, the Management 1/1 default IP address is 192.168.45.45.
• Inside interface (for example, Ethernet 1/2)
• Management 1/1 interface
• Firepower Management Center
• Management computer
Cisco Firepower 2100 Getting Started Guide
Power on the Device
35