(Optional) Change Management Network Settings At The Cli - Cisco Firepower 2100 Getting Started Manual

(Optional) Change Management Network Settings at the CLI

Note
(Optional) Change Management Network Settings at the CLI
If you cannot use the default management IP address, then you can connect to the console port and perform
initial setup at the CLI, including setting the Management IP address, gateway, and other basic networking
settings. You can only configure the Management interface settings; you cannot configure inside or outside
interfaces, which you can later configure in the GUI.
Note
You cannot repeat the CLI setup script unless you clear the configuration; for example, by reimaging. However,
all of these settings can be changed later at the CLI using configure network commands. See the
defense command
Procedure
Step 1 Connect to the FTD console port. See
Log in with the admin user and the default password, Admin123.
You connect to the FXOS CLI. The first time you log in, you are prompted to change the password. This
password is also used for the FTD login for SSH.
Note
Example:
firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
[...]
Hello admin. You must change your password.
Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
Cisco Firepower 2100 Getting Started Guide
136
Before you move the power switch to the OFF position, use the shutdown commands so that the
system can perform a graceful shutdown. This may take several minutes to complete. After the
graceful shutdown is complete, the console displays
panel blue locator beacon LED lights up indicating the system is ready to be powered off. You can
now move the switch to the OFF position. The front panel PWR LED flashes momentarily and turns
off. Do not remove the power until the PWR LED is completely off.
See the FXOS Configuration Guide
reference.
If the password was already changed, and you do not know it, you must reimage the device to reset
the password to the default. See the
It is safe to power off now
for more information on using the shutdown commands.
Access the FTD and FXOS CLI, on page 160
FXOS troubleshooting guide
Firepower Threat Defense Deployment with CDO
for more information.
for the reimage procedure.
. The front
threat