Cisco Firepower 2100 Getting Started Manual page 198

Enable Platform Mode
enable
You are prompted to change the password the first time you enter the enable command.
Example:
ciscoasa> enable
Password:
The enable password is not set. Please set it now.
Enter Password: ******
Repeat Password: ******
ciscoasa#
All non-configuration commands are available in privileged EXEC mode. You can also enter configuration
mode from privileged EXEC mode.
To exit privileged mode, enter the disable, exit, or quit command.
Step 3 Access global configuration mode.
configure terminal
Example:
ciscoasa# configure terminal
ciscoasa(config)#
Step 4 Set the mode to Platform mode.
no fxos mode appliance
write memory
reload
After you set the mode, you need to save the configuration and reload the device. Prior to reloading, you can
set the mode back to the original value without any disruption.
Example:
ciscoasa(config)# no fxos mode appliance
Mode set to platform mode
WARNING: This command will take effect after the running-config is saved and the system has
been rebooted. Command accepted.
ciscoasa(config)# write memory
Building configuration...
Cryptochecksum: c0532471 648dc7c2 4f2b4175 1f162684
23736 bytes copied in 1.520 secs (23736 bytes/sec)
[OK]
ciscoasa(config)# reload
Proceed with reload? [confirm]
Step 5
After restart, view the current mode to confirm the change.
show fxos mode
Example:
ciscoasa(config)# show fxos mode
Cisco Firepower 2100 Getting Started Guide
196
ASA Deployment with ASDM