Cold Weather; Storage; Disposal; Trouble Shooting - Kyocera TJEP 5702551001479 Safety And Operation Instructions

• Use TJEP lubicator in the air plug (H) of the coil
nailer at least twice a day (depending on frequency
of use).
• Avoid any use of solvent base cleaner to clean
the coil nailer, as certain solvent will damage or
weaken the composite parts of the coil nailer.
• All screws and nuts should be kept tight and
undamaged. Loose screws may result hazard situ-
ations and cause severe personal injury or parts
breakage.
• It is recommended to use a filter and regulator on
the compressor.
• On a daily basis empty the compressor tanks for
water.
• NEVER use a tool if there is any doubt.

Cold weather

• When operating the coil nailer in temperatures
near and below freezing, the moisture in the air
line may freeze and prevent the coil nailer from
operating.
• Reduce the air pressure to 80 psi (5.5 bar) or less.
• Remove all nails from the magazine.
• Connect the compressor and blank-fire the coil
nailer, as slow speed operation tends to warm up
the moving parts.

Storage

• When not in use for an extended period, apply
a thin coat of lubricant to the steel parts to avoid
rust. Do not store the coil nailer in a cold weather
environment. When not in use, the coil nailer
should be stored in a warm and dry place. Keep
out of childrens reach.

Disposal

• Disposal of the coil nailer must be carried out
according to the instructions given by the local
authorities.
160

Trouble shooting

Status
The coil nailer is leaking
air
The coil nailer is blank-
firing
No feed of nails
Lack of power
Nails jam i the coil nailer
For failure other than above situations, please stop using the
coil nailer and contact your local dealer for service.
Meaning
• Loose nose screws
· Tighten screws and
recheck
• Loose cap screws
· Tighten screws and
recheck
• Damaged seal or gasket
· Replace seal or gasket
• Dirt in nose (B+C)
· Clean nose
• Dirty/empty magazine (I)
· Clean magazine
• Air restriction/inadequate air
flow
· Check hose and
compressor
• Lack of lubrication
· Use TJEP lubricator
• Fasteners too short or wrong
size for the coil nailer
· Use recommended TJEP
nails only
• Bent fasteners
· Do not use
• Low air pressure
· Check hose and
compressor
• Lack of lubrication (H)
· Use TJEP lubricator
• Wrong size of nails
· Use recommended TJEP
nails only
• Bent fasteners
· Do not use
• Loose magazine, nose
screws
· Tighten all screws and
recheck