Working With Alarm - Tecsun R-108 Operation Manual

3. Press the [TIME] button to confirm the setting.
Note：If you do not press the [TIME] button for 3 seconds to confirm,
the radio will automatically exit the adjustment
Set the alarm time
1. Press & hold the [ALARM] button until hours flashing, then
rotate the [TUNING] knob to adjust the hour;
2. Press the [ALARM] button, then rotate the [TUNING] knob
to adjust the minutes while minutes is flashing ;
3. Press the [ALARM] button
rotate the [TUNING] knob to adjust the automatic off time after
power on (1-90 minutes);
4. Press the [ALARM] button to confirm the setting.
Note： ： If you do not press the [ALARM] button for 3 seconds to
confirm, the radio will automatically exit the adjustment.

►WORKING WITH ALARM

You can press the [ALARM] button repeatedly to activate/deactivate
the alarm by buzzer / radio.
1. If " " shows on the display with a sound of "B", it means
the alarm by radio is turned on.
2. If " " shows on the display with a sound of "BB", it means
the alarm by buzzer is turned on.
3. If " " / " " does not show on the display with a sound of "B---", it
means the alarm by buzzer / radio is turned off.
METHOD1: SET THE ALARM BY RADIO
(You should pre-store the radio frequency before setting the alarm by
radio)
1. Turn on the radio, then tune into your favorite station for alarm
by radio and adjust your desired alarm volume level.
2. Press& hold the [ALARM] button with ""
station.
until you hear a sound of
13
www.tecsunradios.com.au
"BB--", then
" flashing to store