Tecsun R-108 Operation Manual page 10

DELETE MEMORY
1. Select your desired band by pressing
Press the [VM/VF] button to switch into frequency mode, switch
2.
to address status;
Press & hold the [DELETE] button until "DEL" and "memory
3.
address" flashing;
4. Rotate the [TUNING] knob to select the memory that you want to
delete;
Press the [DELETE] button to remove the unwanted
5.
memory address.
AUTO BROWSE MEMORY (Refer to 11)
1. Select your desired band by pressing [BAND] button;
2. Press the [VM/VF] button to switch into frequency mode, switch to
address status, with memory address number flashing;
3. Press & hold
another, staying on each station for about 5 seconds.
4. To stop auto search memory, simply press the
SQUELCH SETTING
1. Press the [POWER] button to turn on the radio and
desired band by pressing
2. Press & hold [SQUELCH] button，Switch to the signal strength
selection page；
3. Rotate the [TUNING] knob to
4. Press the [SQUELCH] button again to confirm
SWITCH SOUND MODE
1.Turn on the radio and select any band you desired ；
2. Press & hold number"4"button，and then switch the sound mode
MUSIC/VOICE.
TUNING SPEED SETTING
1. Turn on the radio and select any band you desired；
2. Press the [SQUELCH] button to select Fast/Slow speed or
select Stop to lock station.
(Refer to 11)
/
button, auto scan from one memory to
(Refer to 17)
[BAND] button；
select signal strength；
(Refer to 16)
(Refer to 17 )
7
www.tecsunradios.com.au
[BAND] button;
/ button.
select your