Tecsun R-108 Operation Manual page 13

2. Press & hold the [BAND] button until "PRESET" flashing and the
frequency counting; now the unit starts scanning and storing all
available SW band stations into the memories；
3. When the frequency stops advancing, it means the ATS operation
is done completely. In the address state, you can rotate the
[TUNING] knob to browse for those stored stations.
●AIR ATS
1. Fully extend the telescopic antenna and press the [BAND] button
to select AIR band;
2. Press & hold the [BAND] button until "PRESET" flashing and the
frequency counting; now the unit starts scanning and storing all
available AIR band stations into the memories;
3. When the frequency stops counting, it means the ATS operation
is done completely. Now you can rotate the [TUNING] knob to
search for those stored stations.
Notes:
1. During ATS process in FM, MW / LW / SW or AIR, pre-stored radio
stations will be replaced automatically by the new found stations;
2. If there is too much interference in your surrounding or many
mirror/blank stations are being stored during ATS, you should
adjust the telescopic antenna (FM & SW) or rotate the radio for
better reception (MW & LW).
METHOD 2: STORING STATON MANUALLY
1.Select band and tune to your desired
[MEMORY]
2. Press the
3. Rotate the [TUNING] button to select the location you want
to store;
4. Press the [MEMORY]
indicating that the station has been stored into memory.
Note: If you do not press the [MEMORY] button again within
3 seconds, the radio will automatically exit the storage.
button with "PRESET " flashing;
button again, and hear a sound of "Be—" ,
10
www.tecsunradios.com.au
station；