Sony CMT-101 Operating Instructions Manual page 9

Step 3: Presetting radio stations
(continued)
3
Press TUNING MODE repeatedly
until "AUTO" appears.
4
Press + or – to tune in the station
you want to store.
The frequency indication changes and
scanning stops when the system tunes in
the station. "TUNED" and "STEREO"
(for a stereo programme) appear.
5
Press EDIT/NO repeatedly until
"Frq-Memory?" appears.
6
Press YES.
The preset number flashes in the display.
7
Press ? or / and select the preset
number you want.
8
Press YES.
The station is stored.
9
Repeat steps 2 through 8 to store
other stations.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
"AUTO" and "PRESET" disappear in step 3,
then press + or – to tune in the station.
To change the preset number
Start again from step 2.
8
To change the AM tuning interval
(Except for European models)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval to 10 kHz (or 9 kHz), press TUNER/BAND
repeatedly until "AM" appears first, then turn off
the power. While holding down +, turn the power
back on.
When you change the interval, the AM preset
stations will be erased. To reset the interval, repeat
the same procedure.
Note
The preset stations are retained for a week even if
you pull out the mains lead or if a power failure
occurs.