Sony CMT-101 Operating Instructions Manual page 64

Compact component system
Table of Contents

Advertisement

CD Player
The CD can not be inserted.
• Check if another CD is inserted already.
The CD can not be removed.
• Press 6 of the tuner CD player for more
than 2 seconds.
The CD will not play.
• The CD is dirty.
• The CD is inserted label side down.
• Moisture condensation has built up.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
Play does not start from the first track.
• The player is in programme or shuffle
mode. Press PLAY MODE until
"SHUFFLE" or "PROGRAM" disappears.
MD Deck
(for the customers who purchased
MDS-MX101 only)
The programme is not recorded, which
must have been recorded or edited.
• The mains lead was disconnected without
removing the MD from the MD deck after
recording or editing.
Be sure to remove an MD after recording
or editing because programme you made
is put on record on an MD when an MD
is removed.
The MD can not inserted.
• Check if another MD is inserted already.
The controls do not work.
• The MD is dirty or scratched. ("Disc
Error" appears.) Replace the MD with a
new one.
The MD will not play.
• Moisture condensation has built up.
Remove the MD and leave the system
turned on for several hours until the
moisture evaporates.
• Insert the MD in the direction of the
arrow.
• Nothing is recorded on the MD.
Recording is not possible.
•The MD is protected against erasure.
("MD Protected" appears.) Slide the tab
to close the slot (see page 59).
•Connect the sound source properly.
•A premastered MD is inserted in the
deck. Replace the disc with a recordable
MD.
•Replace the disc with a recordable MD
that has sufficient time remaining or erase
unnecessary tracks.
•The mains lead was unplugged or a
power interruption occurred during
recording. Start recording over from the
beginning.
Cassette deck
(for the customers who purchased
TC-TX101 only)
The cassette can not be inserted.
•Check if another cassette is inserted
already.
Recording is not possible.
•The tab on the cassette is broken off.
Cover the broken tab with adhesive tape.
•The tape has reeled to the end.
CD Synchronized recording does not start.
•When you set DIRECTION to a,
recording does not start if the tab of either
side is removed from the cassette.
The sound is not clear and there is a
decrease in sound level.
•The heads are dirty. Clean them.
•Magnetic deposits have built-up on the
record/playback head. Clean them.
The sound drops out.
•The capstans or pinch rollers are
contaminated. Clean them.
continued
63

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hcd-101

Table of Contents