Troubleshooting - Sony CMT-101 Operating Instructions Manual

System limitations of MDs
(continued)
Notes
• This copy management system doesn't apply
when you make a recording through analog-to-
analog connections.
• To make a digital recording of a digital satellite
broadcast programme, whose sampling frequency
is 32 kHz or 48 kHz, you need an MD deck or a
DAT deck that supports these frequencies. You
can also make a second-generation copy.
62

Troubleshooting

If you run into any problem using this stereo
system, use the following check list.
First, check that the mains lead is connected
firmly and the speakers are connected
correctly and firmly.
Should any problem persist, consult your
nearest Sony dealer.
General
There is no sound.
•Adjust the volume.
•The headphones are connected.
There is severe hum or noise.
•A TV or VCR is placed too close to the
stereo system. Move the stereo system
away from the TV or VCR.
"0:00" (for European model) or "12:00AM"
(for other models) flashes in the display.
•A power interruption occurred. Set the
clock and timer settings again.
The timer does not function.
•Set the clock correctly.
"DAILY" or "REC" does not appear even if
you press TIMER SELECT.
•Set the timer correctly.
The remote does not function.
•There is an obstacle between the remote
and the system.
•The remote is not pointing in the
direction of the system's sensor.
•The batteries have run down. Replace the
batteries.
Sound comes from one channel or
unbalanced left and right volume.
• Check the speaker connection and
speaker placement.
• Press BALANCE L or R repeatedly until
"CENTER" appears.