Sony CMT-101 Operating Instructions Manual page 28

4
Press CHARACTER on the remote
repeatedly until the desired type of
character appears.
Each time you press the button, the
display changes as follows:
A (Upper cases) n a (Lower cases) n 0
(Numbers)/! (Symbols)* n
n A...
*You can use the following symbols.
! " # $ % & ' ( )
_ `
5
Press + or – on the remote until the
desired character appears.
The selected character flashes. To enter a
blank space, press / on the remote
while the cursor is flashing.
6
Press / on the remote.
The character you selected in step 5
lights up and the cursor shifts to the
right.
7
Repeat steps 4 through 6 to
complete the entire title.
If you make a mistake, press ? or / on
the remote until the character you want
to change flashes, then repeat steps 4
through 6.
To erase the character, press EDIT/NO
while the character is flashing.
If you try to labell more than 10
character, "Name Full" is displayed.
(Space)
+ , – . / : ; < = > ? @
8
Press YES to complete the labelling
procedure.
The disc name is displayed.
To cancel labelling
Press p.
To erase a disc name
1 Press EDIT/NO repeatedly until "Name
Erase ?" appears.
2 Press YES.
The disc name appears.
"No Name" appears if no disc name is
stored.
3 Press YES again.
"Complete" appears and the disc name is
erased.
Note
You can not labell during playing a CD.
27