Chapter 11 Error Code List - Brother BES-962BC Instruction Manual

Code
When the power is turned on, bed can not be re-
E-1E
tracted.
Presser foot down error while searching for home
E-1F
position just after the power is turned on.
E-21 Hoop overhang(+X)
E-22 Hoop overhang(+Y)
E-23 Hoop overhang(+X, +Y)
E-24 Hoop overhang(-X)
E-25 Hoop overhang(+X, -X)
E-26 Hoop overhang(-X, +Y)
E-27 Hoop overhang(+X, -X, +Y)
E-28 Hoop overhang(-Y)
E-29 Hoop overhang(+X, -Y)
E-2A Hoop overhang(+Y, -Y)
E-2B Hoop overhang(+X, +Y, -Y)
E-2C Hoop overhang(-X, -Y)
E-2D Hoop overhang(+X, -X, -Y)
E-2E Hoop overhang(-X, +Y, -Y)
E-2F Hoop overhang(+X, -X, +Y, -Y)
E-31 Needle overhang(+X)
E-32 Needle overhang(+Y)
E-33 Needle overhang(+X, +Y)
E-34 Needle overhang(-X)
E-36 Needle overhang(-X, +Y)
E-38 Needle overhang(-Y)
E-39 Needle overhang(+X, -Y)
E-3C Needle overhang(-X, -Y)
The status of presser foot is issued as an alarm when
E-40
every second machine is used.
E-41 Invalid start-up error
E-42 XY movement error
Error
BES-962BC • BES-1262BC
This is displayed when every other head control is selected or when the
bed is retreated (including when the power is turned on). Remove the
presser foot of the retreating head and press the return key or turn the F/B
switch of the head to either side. If every other head control is not selected
or the bed is not retreated, the bed sensor position may be faulty. Readjust
it. Press the key. If the same error occurs again, adjust it with the
STOP
presser foot switch.
Press the or turn on the F/B switch on the head to either side. If the
STOP
same error occurs again, adjust the presser foot switch.
Pattern or the needle position is out of the embroidering area. Reset the
embroidering area on PC or move the hoop to the sewable position.
When using the every other head mode, remove the presser feet according
to the warning message.
Turn the power off and on once.
Press the or turn on the F/B switch on the head to either side.
STOP

Chapter 11 Error code list

Measures
247