Brother BES-962BC Instruction Manual page 53

Holder base (optional)
w
o
q
w
Attaching the holder base frame
1. Set the table. (Refer to "2-4 Mounting of Table" (Page 32) for details.)
2. Insert the frame connecting plate F r into the holder base frame LN q, holder base frame CN
w, and holder base frame RN e, using bolts and washers.
3. Remove four bolts y from the front of X-feed frame t. Attach one each of square nut M6 u
to the right and left sides at the front.
At the rear of the frame, attach three each of square nuts M6 u to the right and left sides.
4. Put frame connecting plates RN i and LN o on X-feed frame t. Fix them with bolts and
washers.
5. Check that the clearance between the table and the mounted holder base frame C assembly
w is even when viewed from the machine front.
Loosen three bolts of the F table support F !0 and move it in the direction of the arrow for adjust-
[Adjustment]
ment.
t
y
o
!2
!0
r
BES-962BC • BES-1262BC
Chapter 2 Preparation of Embroidery Machine
i
y
Felt
Table
i
Do not remove
these screws.
e
!3
u
q,e
!1
1mm
1mm
!3
51