Ioline CrystalPress Quick Start Manual page 4

Installing Bracket Tape
1
Peel the backing from the strips of
4" tape (Included) and place them
in the bowl bracket as shown. If the
tape is already installed and in good
condition, this step is not necessary.
Remove the 2 Phillips screws from
2
the front of the old bowl and in-
stall them into the new bowl. Don't
screw them all the way in, leave
them as far out as possible for now.
Locate the 3 bowl stud slots in the
3
bowl plate on the machine and on
the bottom of the bowl assembly.
NOTE: Make sure three plastic
washers included with the assembly
are in place on each of the align-
ment studs on the bottom of the
bowl.
Plug in the two wires shown to the
4
bowl circuit board. Make sure the
connectors are lined up properly
with the circuit board connector.
Installing the bowl
Encoder
Tape
Bowl stud slots (3)
Power
4
14140 NE 200th St.
Woodinville, WA 98072 USA
1.425.398.8282
www.ioline.com
Bowl studs (3)
Plug in both wires to the
bowl circuit board.