Ioline CrystalPress Quick Start Manual page 3

Slide the bowl forward until the
1
center stud clears the front plate
on the front of the bowl.
Carefully remove the bowl assem-
2
bly from the machine. Lift up on
the bowl assembly until the bottom
studs clear the machine. Then pull
out slowly as far as the wires will
allow.
The bowl wiring should come out
3
smoothly with the bowl. If there is
resistance from the wires don't pull
on them as this might damage other
components of the machine.
NOTE: The wiring is bundled with
cable ties. They can get caught on
the opening in the base bracket as
the wiring is pulled out. Wiggling
the wires while pulling avoids this.
Unplug the two wires shown from
4
the bowl circuit board.
Encoder Power
3
14140 NE 200th St.
Woodinville, WA 98072 USA
1.425.398.8282
www.ioline.com
Bowl Center Stud
Unplug both encoder
and power wires from
bowl circuit board.