1
: Check the buffers (1) and replace
if necessary, b 9.3.2
Installing
– Position filter base in the
carburetor box.
– Install the switch lever, b 10.1
– Fit the contact spring, b 7.7.4
3
2
1
– Use STIHL press fluid to simplify
assembly, b 14
: Push peg (1) on filter base (2)
into the bore in the buffer (3) as
far as stop.
82
All manuals and user guides at all-guides.com
1
1
3
2
: Line up the filter base (1) so that
the peg (2) is under the lug (3).
1
: Push the filter base (1) onto the
studs (arrows) and the
carburetor.
– Use STIHL press fluid to simplify
assembly, b 14
: Push the filter base (1) into the
buffer (2) – collar of peg must
project fully on the other side of
the buffer.
– Install the choke rod, b 10.3.3
3
1
2
: Use punch-down tool
5910 890 4000 to press the short
circuit wire (1) into the
guides (arrows) so that the
marking (2) is at the edge of the
guide and the protective tube (3)
locates below the guide rib.
1
2
1
: Use punch-down tool
5910 890 4000 to press the
ground wire (1) into the
guides (arrows) so that the
marking (2) is at the edge of the
guide.
2
– Check operation of switch lever.
– Reassemble all other parts in the
reverse sequence.
MS 231, MS 231 C, MS 251, MS 251 C