Stihl MS 231 Manual page 52

1
: Pull out the grommet (1) with
wiring harness.
1
: Take the short circuit wire (1) out
of the guides (arrows).
2
1
: Pry the terminal sleeve (1) out of
the guide (arrow).
: Remove the Master Control
lever (2).
MS 231, MS 231 C, MS 251, MS 251 C
All manuals and user guides at all-guides.com
Installing
The protective tube (1) must locate
in the grommet's bore.
: If necessary, push the wiring
harness into the grommet until
the protective tube (1) locates in
the grommet (2).
2
1
: Position the wiring harness (1) so
that the protective tube (2) points
towards the ignition module.
2
1 2
: Push the grommet (1) into the
recess (arrow) in the air guide
shroud (2) until it is flush with the
outside edge.
The ground wire (1) must be below
the short circuit wire (2).
2
1
: Position the wiring harness (1) in
the retainer (2) so that about 5
mm (a) of the protective tube (3)
is held as shown – the protective
tube must be pushed into the
grommet as far as stop.
1
2
1
3
51