Buffers On Filter Base; Handlebar - Stihl MS 231 Manual

9.3.2

Buffers on Filter Base

– Remove the filter base, b 12.3
1
: Take out the screw (1).
: Press the tank housing (2) down
a little and hold it there.
1
: Push out the buffers (1) from the
underside (arrows).
– Check the buffers (1) and replace
if necessary
MS 231, MS 231 C, MS 251, MS 251 C
All manuals and user guides at all-guides.com
Installing
1
2
: Position the buffers (1)
with their tapered ends facing the
bores (arrows).
– Use STIHL press fluid to simplify
assembly, b 14
: Push the tapered ends of the
buffers (1) fully into the
bores (arrows), turning them
back and forth to simplify
1
installation.
The tapered ends (arrows) must be
properly seated on the other sides
of the bores.
2
1
: Push the tank housing (1)
upwards and hold it there.
: Insert and tighten down the
screw (2) firmly.
– Reassemble all other parts in the
reverse sequence.
9.4

Handlebar

– Remove the shroud, b 6.4
: Take out the screw (1).
1
1
69