Stihl MS 231 Manual page 55

Installing
1
2
: Push the sleeve (1) into the
loop (arrow) of contact spring (2)
as far as stop.
2
1
: Position the contact spring (1)
against the guide (arrows).
: Lift the contact spring (1) a little
and ease it over the tab (arrow).
– take care not to overstretch the
contact spring.
Before pushing the contact
spring (1) fully home, lift it a little
and ease it over the switch level –
no more than 2 mm.
54
All manuals and user guides at all-guides.com
: Push the contact spring (1) into
the guide (arrows) until it is
engaged by the tab.
– Install the filter base, b 12.3
: Check operation
– short circuit wire's terminal
sleeve must touch the contact
spring (arrow) in position "
– Reassemble all other parts in the
reverse sequence.
1
1
0
".
MS 231, MS 231 C, MS 251, MS 251 C