Stihl MS 231 Manual page 53

2
1
: Fit the ground wire (1) and short
circuit wire (2) in the
guides (arrows).
1
2 4 3
Ground wire: Crimped side of
terminal (1) must face outwards.
: Position the terminal (1) between
the ignition module (2) and
stop (3).
– Check the air gap between the
ignition module and flywheel and
adjust if necessary, b 7.3
: Fit the screw (4) with washer and
tighten it down firmly.
: Press the ground wire (5) fully
into the guide (arrow).
52
All manuals and user guides at all-guides.com
1
2
Short circuit wire: Crimped side of
terminal (1) must face outwards.
: Connect terminal of short circuit
wire (2) – make sure the terminal
is pushed fully home.
: Press the short circuit wire (2)
fully into the guide (arrow).
5
2
Check that the ignition lead (1) is
properly seated in the guide.
: Carefully push the retainers (2)
and (3) into the slots (arrows)
until they snap into place.
– Position filter base in the
carburetor box.
3
1
: Position the switch lever (1) in the
carburetor box.
: Position terminal sleeve (2) of
short circuit wire so that its
crimped side faces the cam (3).
: Push terminal sleeve (2) into the
guide (arrow) as far as stop.
1
3
: Fit the short circuit wire (1) in the
guides (arrows).
– Install the switch lever, b 10.1
– Fit the contact spring, b 7.7.4
– Install the filter base, b 12.3
MS 231, MS 231 C, MS 251, MS 251 C
2
1