Table of Contents
Advertisement
G
UIDELINES FOR WORKING WITH HEAVIER THREADS
FABRIC:
NEEDLES:
THREAD:
PRESSER FOOT:
Instruction Manual pg.___
Bernette
Advanced Guide Workbook Supplement I pg.___
Feet-ures Unit ___pg.___
Serger Library – Tips and Tricks
Attach the Upper Looper Converter.
Following the directions in the Instruction Manual, attach the Deco Guide
over the Lower Looper Tension Slit.
Thread the Lower Looper with the decorative thread. Thread the first Thread
Guide. The thread will pass through the Deco Guide skipping the tension disk.
Turn the Stitch Selection Dial to "E".
Adjust Stitch Length to 4. You can slowly shorten the Stitch Length as you
serge to fill in the Flatlock stitch.
Sew the sample.
If the tension on the decorative thread is too tight, remove the thread from
Thread Guide #5 and try again.
If the tension on the decorative thread is still too tight, remove the thread
from Thread Guide #7 and try again.
If the tension is still too tight, remove the thread from the first Thread Guide
and try again. You may need to rethread guides #5 and/or #7 to slightly
increase the tension.
Experiment with the suggested threads, by-passing Thread Guides as needed.
Press, trim, and mount the samples on the next page.
THE DECO GUIDE
3 pieces of heavy weight cotton 4" X 6"
90/14 Universal
1 cone of serger thread (Needle)
1 cone of each of the following:
YLI Pearl Crown Rayon
Madeira Glamour or YLI Candlelight
Madeira Décor or YLI Designer 6
Standard
Specialty Stitches
Simply Serging
1999 BERNINA Of America
Section D - page 6
Advertisement
Table of Contents
