Table of Contents
Advertisement
InSTAllATIOn
sections
1
2
3
4
5
table of contents
Changing the network parameters
Enable DHCP – When a DHCP server is active on the same network to
which the Switch is connected, DHCP provides automatic IP assignment .
When DHCP is disabled (Recommended) – You can assign a fixed IP
address to the Switch .
Consult your network administrator regarding the use of the DHCP .
When DHCP is disabled, enter the IP Address, Subnet Mask, and
Gateway as given by your network administrator .
Once the IP address is satisfactory, log in to the web interface to
complete the configuration, as explained in the next section .
(Network parameters can also be changed from the remote GUI as
explained on page 17) .
14
OmniView
SMB CAT5 216/232 Switch
®
Advertisement
Table of Contents
