Service And Repairs; Wheels - Toro Pro Sweep 5200 Service Manual

Service and Repairs

Wheels

RIGHT
FRONT
1. Main frame
2. Lug nut (5 used per wheel)
Wheel Removal (Fig. 2)
1. Position sweeper on a level surface with dump hop-
per empty and lowered. Have sweeper attached to tow-
ing vehicle, engage vehicle parking brake, stop engine
and remove key from the ignition switch. Chock sweep-
er wheels to prevent sweeper from moving.
2. Jack or hoist sweeper from ground and support ma-
chine with blocking or jack stands (see Operator's
Manual and Jacking Instructions in Chapter 1 – Safety).
3. Loosen and remove five (5) lug nuts from wheel to be
removed.
4. Pull wheel from sweeper.
Pro Sweep 5200
Figure 2
3. Wheel and tire assembly
Wheel Installation (Fig. 2)
1. Position wheel to wheel hub.
Failure to maintain proper lug nut torque
could result in failure or loss of wheel and may
result in personal injury.
2. Secure wheel to sweeper with five (5) lug nuts. Alter-
nately torque lug nuts from 70 to 90 ft–lb (95 to 122
N–m).
3. Lower machine to ground.
Page 5 – 3
1
70 to 90 ft–lb
(95 to 122 N–m)
4
4. Wheel hub
WARNING
2
3
Chassis