Maintenance; Service Interval Chart; Cleaning Hopper Screens - Toro Z-Master Operator's Manual

Maintenance

Service Interval Chart

Service Operation
Belts – check for wear/cracks
Hopper – clean
Screens – clean (as required)
Chipped Surfaces – paint

Cleaning Hopper Screens

For best clipping collection, maximum air flow
through the hopper is required. To provide maximum
air flow, the hopper screens must be kept clean.
1. To clean the hopper screens dump the hopper to
remove grass clippings.
2. With the door open, remove the knobs at the
upper front of the hopper and slide the screens
out the rear of the hopper (Fig. 28).
18
Each 50 Storage
Use Hours Service
X
X X
X
X
3. Clean the screen by brushing off with your hand,
blowing with compressed air or spraying with a
stream of water.
4. Replace the screens and secure with knobs
(Fig. 28). Close and latch the hopper door.
1
1. Knob
Notes
Figure 28
2. Screen
2
m–3546