Miele TXI 680 WP Operating Instructions Manual page 58

Frequently Asked Questions
Message

Empty container See
 lights up after
a program has
been cancelled.

Fill the condensed
water container

Open & close door

Blockage detected.
See  lights up
after a program
has been
interrupted.

 Service Fault F
lights up
XXX
after a program
has been
interrupted.
58
Possible cause and solution
The condensed water container is full or there is a
kink in the drain hose.
 Empty the condensed water container.
 Check the drain hose.
To switch the fault message off:
 Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
This is to remind you that water is taken from the
condensed water container when the
program is being used. The condensed water
container must be filled with water to at least the
–min– marker.
 Fill the condensed water container.
To switch off the message:
 Confirm with OK.
This is to remind you to load the laundry when the
SoftSteam program is selected.
 Load the laundry in the drum.
The laundry is unevenly distributed or has rolled up.
 Open the door and untangle the laundry, and
remove a few items, if necessary.
 Switch the dryer off and then on again.
 Start a program.
There is no obvious cause.
 Switch the dryer off and then on again.
 Start a program.
If the program is interrupted again and an error
message appears, there is a fault. Contact Miele
Technical Service.
SoftSteam