Omron NS7 Series Setup Manual page 86

3-8 Installing the Controller Link Interface Unit
Reference
● Connecting the Connector to the Board
Connect the connector on the communications cable to the connector on the Board using the
following procedure.
1. Insert the connector on the communications cable into the connector on the Board as
shown below.
2. Secure the connector to the Board by tightening the screws on the connector. The appli-
cable tightening torque is 0.2 N × m.
3-54
Small flat-blade
screwdriver with a
uniform width
The following screwdriver is available from OMRON.
Model XW4Z-00C
Front
Side
0.6 mm 3.5 mm
Cable connector
Controller Link
Support Board