Sony VPL-CX76 Operating Instructions Manual page 32

Message
Unable to switch
resolution of PC desktop.
LAN Module with same
network address exists.
USB Wireless LAN
Module disconnected
while connecting.
System error/Quit Air
Shot v2
The same IP Address
already exists.
Wireless LAN Card not
inserted.
Incompatible Card
mounted.
File access error has
occurred.
Specified file format is
not supported.
Specified file is not Root
Certificate.
Specified file is not Client
Certificate.
Specified file is not
Private Key.
Cannot open the Private
Key.
32
Others
PC PJ Cause and Remedy
a
• When the screen resolution of the computer is not
identical with the projector LCD panel resolution, and
when the computer is connected to the projector with
[Set PC desktop to Projector resolution] of the [Option
Setting]-[Connection Setting] checked, the resolution
switching of the computer cannot be done successfully.
c If the message appears every time the computer is
connected to the projector, uncheck [Set PC desktop to
Projector resolution].
a • The IP address on the same subnet mask which is used
by the Air Shot Version 2 LAN module has been
assigned to another LAN module.
c Check the IP Address Setting of the LAN module used
with the Air Shot Version 2 and that used in the
computer. Then change the settings so that their
network addresses are not identical.
a
• While the computer is connected to the projector, the
USB wireless LAN module is removed.
c If the USB wireless LAN module is removed during
connection, the computer may become unable to
establish proper connection with the projector. To
remove the USB wireless LAN module, make sure to
disconnect the device.
a
• Because of the lack of system resources in the computer,
you cannot start the Air Shot Version 2 properly.
c Restart Windows and start the Air Shot Version 2.
a a • The set IP address is already in use.
c Input a new IP address.
a
• The wireless LAN card is not inserted correctly into the
slot of the projector.
c Check the card direction and insert until it stops.
a • The supplied wireless LAN card is not used.
c Use the supplied wireless LAN card.
a • The "Memory Stick" was removed during file access.
c Do not remove the "Memory Stick" during file access.
a • The file format of the specified file is not compatible.
c Check the file format of the certificate to be added.
a • The specified file is not a Root Certificate file.
c Specify a Root Certificate file.
a
• The specified file is not a Client Certificate file.
c Specify a Client Certificate file.
a
• The specified file is not a Private Key file.
c Specify a Private Key file.
a
• The Private Key Password is incorrect.
c Check the Private Key Password.