Sony VPL-CX76 Operating Instructions Manual page 30

Message
No connectable Projector
has been found.
Unable to configure
Simple Mode.
A projector using the
Simple Mode connection
is not registered.
Network communication
error.
Projector communication
error.
Projector communication
password error.
30
Others
PC PJ Cause and Remedy
a
• The Air Shot Version 2 communications are blocked
because of the Firewall.
c See the "Troubleshooting".
• Wireless transmission conditions are extremely bad.
c Place the projector close to the computer, or remove the
obstacles between the projector and computer.
• The projector with a different serial number from those
of the projector you want to connect is selected. (In the
Simple Mode)
c Check the serial number of the projector you want to
connect, and change the projector to be connected in
the [Simple Mode Setting] of the [Option Setting]
dialog box.
• The Wireless Network Setting of the projector is not
identical with those of the computer. (In the Manual
Mode).
c Check and re-set the Wireless Network Setting for both
the projector and computer.
a
• Simple Mode Setting cannot be done successfully.
c Click the [Close] button to close the main window and
then open it and make the Simple Mode Setting.
c Remove and then insert the USB wireless LAN
module, and make Simple Mode Setting.
c Restart Windows, and then make Simple Mode Setting.
• The Windows IP Address Setting of the USB wireless
LAN module is not set to Auto(DHCP) (only when
Windows 98SE/Me in the Simple Mode is used).
c Set the Windows IP Address Setting of the USB
wireless LAN module into Auto(DHCP).
a
• The projector to be connected in Simple Mode is not
registered.
c Click [Option Setting], [Simple Mode Setting] and
[Add], and then input the serial number of the projector
that you want to connect to register it.
a • The computer is unable to perform proper network
communications.
c Restart Windows and start Air Shot Version 2.
c Check the setting of the USB wireless LAN module
used in the Air Shot Version 2.
a
• Wireless transmission conditions are extremely bad.
c Place the projector close to the computer, or remove the
obstacles between the projector and computer.
a
• The password specified with the projector is not
identical with those specified with the computer.
c Set the same password to the computer as the projector
in the [Profile Setting] of the [Option Setting] dialog
box.