Sony VPL-CX76 Operating Instructions Manual page 31

Message
The Projector is busy.
Selected PC is busy.
Request for connection/
disconnection rejected.
Projector connection
established already.
Selected PC exceeds
maximum number of
connection.
Projector is stand-by.
No response from
projector.
PC PJ Cause and Remedy
a
• The projector you are trying to communicate is
performing turning on/off operations.
c After the projector operations are complete,
communicate it and turn it off again.
• The [Setting] window of the projector is open.
c Close the [Setting] window and then communicate it
and turn it off again.
a
• The computer you are trying to communicate is
performing turning on/off operations.
c After the computer operations are complete,
communicate it and turn it off again.
• The [Option Setting] window is open.
c Close the [Option Setting] window and then
communicate it and turn it off again.
a
• The [Option Setting] -[Connection Setting] - [When
Connection/Disconnection request is received] is set to
[Always No].
c Set it either to [Display Confirm Dialog] or [Always
Yes].
a
• The computer cannot communicate with the projector as
the other computer has already established
communications with the projector.
c After the projector is disconnected from the computer,
communicate with the projector again.
a • You tried to connect more than 5 projectors to one
computer.
c Reduce the number of the connected projectors to 4 or
less and then connect it again. (The maximum of 5
projectors can be connected to one computer.)
• The projector you are trying to communicate is in the
standby mode.
c Turn on the projector and then try communicating it.
a
• The Air Shot Version 2 communications are blocked
because of the Firewall.
c Change the Firewall settings so that the Air Shot
Version 2 communications are not blocked.
• Wireless transmission conditions are extremely bad.
c Place the projector close to the computer, or remove the
obstacles between the projector and computer.
• The power cord of the projector is removed.
• The wireless card is removed from the projector.
c Check the projector status.
• While connecting to the projector by using the USB
wireless LAN module, the USB wireless LAN module
is removed.
c Restart Windows and start the Air Shot Version 2, and
then connect the USB wireless LAN module.
31
Others