Power Management Setup - JETWAY XBLUE77A3 User Manual

Hide thumbs

Table Of Contents

Table of Contents

↑↓→← : Move Enter: Select +/-/: Value F10: Save ESC:Exit F1:General Help

F5:Previous Values

Onboard Floppy Controller

Select Enabled if your system has a floppy disk controller (FDD) installed on the system

board and you wish to use it. If you install add-on FDC or the system has no floppy drive,

select Disabled in this field. The settings are: Enabled and Disabled.

Serial Port1 Address/ Serial Port2 Address

Use this item to select serial port address for serial port one.

IrDA Mode Select

This item allows BIOS to select mode for serial port 2.

The optional settings are: IrDA(1.6 ns) and IrDA (3/16 bit).

IrDA Duplex Mode/Serial Port 2 Mode

This item allows BIOS to select full or half duplex for serial port 2(IR Mode).The optional

settings are: Full Duplex; Half Duplex.

IrTX Pin Select

The optional settings are: Normal and Inverse.

This item allows BIOS to select transmit pin in a normal condition or inverse the IRTX(IR

Mode).

IrRX Pin Select

The optional settings are: Normal and Inverse.

This item allows BIOS to select receiver pin in normal condition or inverse the IRRX(IR

mode).

IRTX to RX Delay Select

The optional settings are: No Delay and Reception Delay.

This item allows BIOS to select IR from RX to TX 4 characters time delay for serial port2(IR

mode)

IRRX to TX Delay Select

The optional settings are: No Delay and Transmission Delay.

3-8