Table of Contents
Advertisement
(7) Stick the adhesive part of the LF-2026 Flexible Board while position-
ing it with the two bosses.
If the adhesive force is lowered, cut the Adhesive Sheet as shown
in the figure in the frame and then stick it.
LF-2026 Flexible Board
Adhesive part
P
T O
Shape and sticking position
of the Adhesive Sheet
Adhesive Sheet
Bosses
LF-2026 Flexible Board
(8) Stick the CM Radiation Sheet.
P
T O
CM Radiation Sheet
HDR-PJ800/PJ810/PJ810E/PJ820/PJ820E_L2
(9) Install the Motor A while positioning it with the two bosses, and then
secure it with three screws while turning the Plate of the Motor A.
Tightening torque = 0.18 ± 0.02N · m (1.8 ± 0.2kg f · cm)
Bosses
Motor A
Screw
Screw
Plate of the Motor A
Plate of the Motor A
Screw
Screw
Plate of the Motor A
Screw
Screw
(10) Stick the adhesive part of the LF-2025 Flexible Board while posi-
tioning it with the two bosses.
If the adhesive force is lowered, cut the Adhesive Sheet as shown
in the figure in the frame and then stick it.
Shape and sticking position
Adhesive part
of the Adhesive Sheet
Adhesive Sheet
LF-2025 Flexible
Board
LF-2025 Flexible Board
Boss
Boss
Sheet Metal (B),
Stopper
(11) Install the Motor B while positioning it with the two bosses, and
then tighten three screws in the order shown in the figure below.
Tightening torque = 0.18 ± 0.02N · m (1.8 ± 0.2kg f · cm)
Connect the connector.
Screw
2
Screw
3
Screw
1
Connector
Bosses
Motor B
1-9
– ENGLISH –
(12) Install the Sheet Metal (B), Stopper, Motor B, LF-2025 Flexible
Board while positioning it with the two bosses, and then tighten
four screws in the order shown in the figure below.
Tightening torque = 0.18 ± 0.02N · m (1.8 ± 0.2kg f · cm)
Connect the connector.
Sheet Metal (B),
Stopper,
Bosses
Motor B
LF-2025 Flexible Board,
Connector
4
Screw
Screw
2
1
Screw
Screw
3
Advertisement
Table of Contents
