Table of Contents
Advertisement
1-9 . LENS DEVICE (LSV-1400B) REPLACING METHOD
Note:
A protective Lens Cap is attached to each new
service Lens Block.
Carry out replacement work with this Lens Cap
attached.
Removal
(1) Remove the five screws.
Screw
Screw
Screw
Screw
Screw
(2) Remove the four screws.
Screw
Screw
Screw
Screw
HDR-PJ800/PJ810/PJ810E/PJ820/PJ820E_L2
Lens Cap
(3) Disconnect the connector and peel off the adhesive part of the LF-
2025 Flexible Board.
LF-2025 Flexible Board
Adhesive part
Connector
P
T O
(4) Peel off the adhesive part of the LF-2026 Flexible Board.
LF-2026 Flexible Board
Adhesive part
P
T O
(5) Remove the Sheet Metal (C), Stopper while detaching the four bosses.
Sheet Metal (C),
Stopper
Bosses
Bosses
(6) Peel off the adhesive part of the LF-2063 Flexible Board.
Adhesive part
LF-2063 Flexible Board
(7) Remove the Frame (F-Sub-A), Frame (F-Sub-B), and Ball Bearing
while detaching the two bosses and the shaft.
Shaft
Frame (F-Sub-A),
Frame (F-Sub-B),
Ball Bearing
Bosses
1-6
– ENGLISH –
(8) Remove the six screws and remove the Frame (E-Sub-A), Frame
(E-Sub-B), and Ball Bearing while detaching the four bosses and
the shaft.
Screw
Screw
P
T O
Screw
Screw
Screw
Screw
P
T O
Bosses
Shaft
Bosses
Frame (E-Sub-A),
Frame (E-Sub-B)
Ball Bearing
Advertisement
Table of Contents
