Considerations; Setting The Unit - Vertical; Installation - Trane TAM7A0A24H21SC Installer's Manual

Setting the Unit — Vertical Installation
Table 6. Secure Coil
1. Remove Coil Panel.
2. Remove screw from documentation packet.
3. While the air handler is in the upflow position, use the supplied
screw to secure the coil seal plate to cross member as shown.
Important: The Coil Seal Plate and screw secure the coil in the center
of the air handler. Failure to follow these steps can
prevent the Coil Panel from being easily replaced on the
unit.
Table 7. Considerations
Provide a minimum height of 14 inches for proper unrestricted airflow
below the unit. Allow a minimum of 21 inches clearance in front of the
air handler to permit maintenance and removal of filter.
• Position unit on suitable foundation. If a manufacturer approved
accessory is not used, a frame strong enough to support the total
weight of the unit, accessories, and duct work must be provided.
• Isolate unit from the foundation using a suitable isolating
material.
Note: The following sound insulation kits are available to lessen
objectionable sound.
BAYINSKT175A for use with 17.5" cabinets
BAYINSKT215A for use with 21.5" cabinets
BAYINSKT235A for use with 23.5" cabinets
20
Typ ica l Clo s e t In s ta lla tio n
18-GJ06D2-2A