Download Print this page

Cisco Meraki MR84 Hardware Installation Manual page 6

Advertisement

3.3 Check and Configure Firewall Settings
If your network will be located behind a firewall, it must allow outgoing
connections on particular ports to particular IP addresses in order for the
MR84 to be able to seamlessly communicate with the Cloud Controller. The
most current list of outbound ports and IP addresses can be found here:
http://bit.ly/oZpMQ7
3.4 Assigning IP Addresses to MR84s
All gateway MR84s (MR84s with Ethernet connections to the LAN) must be
assigned routable IP addresses. These IP addresses can be dynamically
assigned via DHCP or statically assigned.
3.4.1 Dynamic Assignment
When using DHCP, the DHCP server should be configured to assign a static
IP address for each MAC address belonging to a Meraki AP. Other features
of the wireless network, such as 802.1X authentication, may rely on the
property that the APs have static IP addresses.
3.4.2 Static Assignment
Static IPs are assigned using the local web server on each AP. The
following procedure describes how to set the static IP:
1. Using a client machine (e.g., a laptop), connect to the AP either wirelessly
(by associating to any SSID broadcast by the AP) or over a wired
connection. If using a wired connection, connect the client machine
to the MR84 either through a PoE switch or a Meraki PoE Injector. If
using a PoE switch, plug an Ethernet cable into the MR84's Ethernet
jack, and the other end into a PoE switch. Then connect the client
machine over Ethernet cable to the PoE switch. If using a Meraki PoE
Injector, connect the MR84 to the "PoE" port of the Injector, and the
client machine to the "LAN" port.
2. Using a web browser on the client machine, access the AP's built-in web
server by browsing to http://ap.meraki.com. Alternatively, browse to
http://10.128.128.128.
3. Click on the "Static IP Configuration" tab. Log in. The default user name is
"admin". The default password is the AP's serial number, with
hyphens included (e.g., Q2BD-551C-ZYW3).
4. Configure the static IP address, net mask, gateway IP address and DNS

Advertisement

loading