Advertisement
access points.
Meraki offers a number of different antennas for use with the MR84: MA-
ANT-20, MA-ANT-25, MA-ANT-27, and AIR-ANT2413P4M-N.
The Meraki MA-ANT-20 omni-directional antennas must be installed
vertically.
The Meraki MA-ANT-25 patch antenna, MA-ANT-27 dual-band sector
antenna, and Cisco AIR-ANT2513P4M-N stadium antenna must be installed
facing downward, at least 30 degrees from the horizon line.
2.3 Power Source Options
The MR84 access point can be powered using either an 802.3at capable
PoE switch or the Meraki 802.3at PoE injector (sold separately).
2.4 LED Indicators and Run Dark Mode
Your MR84 uses a single LED to inform the user of the device's status.
Function
LED Status
Power Up/
Solid Orange
Boot
Connecting
Rainbow
Connected
Solid White
Upgrading
Flashing
White
The MR84 may be operated in "Run Dark" mode for additional security and
to reduce the visibility of the access point. In this mode, the LED will not be
illuminated. This mode may be enabled through Meraki Dashboard.
3 Pre-Install Preparation
You should complete the following steps before going on-site to perform an
Meaning
Power is applied
Device in process of connecting to the
Meraki Dashboard
Fully operational
During boot or no WAN link
Advertisement
