Service Products And Capacities - Mercedes-Benz E-Class 2011 Owner's Manual

Example: vehicle identification plate
Vehicle identification plate
:
Vehicle manufacturer (Daimler AG)
;
EU type approval number (only for certain
=
countries)
Vehicle identification number (VIN)
?
Maximum permissible gross vehicle
A
weight (kg)
Maximum permissible mass of vehicle/
B
trailer combination (kg)
Maximum permissible front axle load (kg)
C
Maximum permissible rear axle load (kg)
D
Paint code
E
Vehicle identification number (VIN)
In addition to being stamped on the vehicle
identification plate, the vehicle identification
number (VIN) is also stamped onto the vehicle
body.
It is located on the floor in front of the right-
hand front seat.

Service products and capacities

Slide the right-hand front seat to its rear-
X
most position.
Fold floor covering : upwards.
X
You will see vehicle identification number
(VIN) ;.
Engine number
The engine number is stamped into the crank-
case. More information can be obtained from
any Mercedes-Benz Service Centre.
Service products and capacities
Important safety notes
G WARNING
When handling, storing and disposing of any
service products, please observe the relevant
regulations, as you could otherwise endanger
yourself and others.
Keep service products away from children.
To protect your health, do not allow service
products to come into contact with your eyes
or open wounds. See a doctor immediately if
any service product is swallowed.
H
Environmental note
Dispose of service products in an environ-
mentally-responsible manner.
Service products include the following:
fuels (e.g. petrol, diesel)
R
additives for exhaust gas aftertreatment,
R
®
e.g. AdBlue
lubricants (e.g. engine oil, transmission oil)
R
coolant
R
brake fluid
R
windscreen washer fluid
R
climate control system refrigerant
R
Components and service products must be
matched. Mercedes-Benz recommends that
you use products tested and approved by
Mercedes-Benz. They are listed in this
383
Z