Memory Function - Mercedes-Benz E-Class 2011 Owner's Manual

and the kerb in the exterior mirror on
the front-passenger side.
Press memory button M ? and one of
X
the arrows on adjustment button =
within three seconds.
The parking position is stored if the
exterior mirror does not move.
If the mirror moves out of position, repeat
the steps.
Calling up a stored parking position set-
ting
Turn the key to position 2 in the ignition
X
lock.
Adjust the exterior mirror on the front-
X
passenger side with the corresponding but-
ton ( page 117).
Y
Engage reverse gear.
X
The exterior mirror on the front-passenger
side moves to the stored parking position.
The exterior mirror on the front-passenger
side moves back to its original position:
as soon as you exceed a speed of
R
10 km/h
about ten seconds after you have disen-
R
gaged reverse gear
if you press button : for the exterior mir-
R
ror on the driver's side

Memory function

Storing settings
G
WARNING
The memory function can still be used when
the key has been removed. For this reason,
children should never be left unsupervised in
the vehicle. They could otherwise become
trapped when adjusting the seat or the steer-
ing wheel.
G
WARNING
Only use the memory function on the driver's
side when the vehicle is stationary. You could
Memory function
otherwise be distracted from the traffic con-
ditions by the steering wheel and seat moving
of their own accord, and as a result, cause an
accident.
With the memory function, you can store up
to three different settings, e.g. for three dif-
ferent people.
The following settings are stored as a single
memory preset:
position of the seat, backrest and head
R
restraint
active multicontour seat: dynamic function
R
level
driver's side: steering wheel position
R
driver's side: position of the exterior mir-
R
rors on the driver's and front-passenger
sides
Adjust the seat (
X
Y
On the driver's side, adjust the steering
X
wheel ( page 115) and the exterior mirrors
Y
( page 117).
Y
Briefly press the M memory button and
X
then press storage position button 1, 2 or
3 within three seconds.
The settings are stored in the selected pre-
set position. A tone sounds when the set-
tings have been completed.
Calling up a stored setting
Press and hold the relevant storage posi-
X
tion button 1, 2 or 3 until the seat, steering
page 106).
119
Z